Solve problems involving Ohm’s Law and electric circuits

/in /by

Week 3 Assignment

Please solve the following problems. You must show all work for full/partial credit. Must be submitted in a word document.

Question 1 :

If a charge particle moves in a straight line and there are no other forces on it, except possibly from a magnetic field, can you say with certainty that no magnetic field is present? Explain.

Question 2 :

In a velocity sector, the uniform magnetic field of 1.5 T is produced by a large magnet. Two parallel plates with a separation of 1.5 cm produce the perpendicular electric field. What voltage should be applied across the plates so that:

  • A singly ionized ion traveling 8.0×10⁴ m/s will pass through undeflected
  • A double ionized ion traveling at the same speed will pass through undeflected

Question 3

A horizontal magnetic field of 1.0×10⁻⁴T is at an angle of 30° to the direction of the current in a straight wire 75 cm long. If the wire carries a current of 15 A, what is the magnitude of the force on the wire?

Question 4

An electron travels at a speed of 2.0×10⁻⁴ m/s through a uniform magnetic field of strength 1.2×10⁻³T. What is the magnitude of the magnetic force on the electron if its velocity and the magnetic field:

  • Are perpendicular
  • Make an angle of 45°
  • Are parallel
  • Are exactly opposite

Question 5

A square loop of wire with sides of length 40 cm is in a uniform magnetic field perpendicular to its area. If the field’s strength is 100 mT and it decays to zero in 0.010 seconds:

  • What is the magnitude of the average emf induced in the loop?
  • What happens to the emf if the side lengths are reduce by a factor of ½?

Question 6

The armature of an ac generator has 100 turns. Each turn is a rectangular loop measuring 8.0 cm by 12 cm. The generator has a sinusoidal voltage output with an amplitude of 24 V. If the magnetic field of the generator is 250 mT:

  • With what frequency does the armature turn?
  • If you double the B and cut w in half, how does this affect the amplitude?

Question 7

An ac generator supplies 20 A at 440 V to a 10,000 V power line. If the step up transformer has 150 turns in its primary coil, how many turns are in the secondary coil?